Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C | Page 42
Figure 29 – Radio Settings – RF Settings
Radio Capabilities
Frequency Range and Output Power Range
Frequency Range and Output Power Range are factory set and vary as determined by Viper model or product
catalog number and the organization determining compliance for the country or geographical area in which the
Viper is to be operated.
140-5018-502: VHF, 136.000-174.000 MHz, 6.25 - 50 kHz bandwidth, 1-10 W
140-5018-503: VHF, 136.000-174.000 MHz, 6.25 - 50 kHz bandwidth, 1-10 W – Dual RF Ports
140-5028-504: VHF, 215.000-240.000 MHz,, 6.25 - 100 kHz bandwidth, 1-10 W
140-5028-505: VHF, 215.000-240.000 MHz, 6.25 - 100 kHz bandwidth, 1-10 W – Dual RF Ports
140-5048-302: UHF Range 3, 406.1125-470.000 MHz, 6.25 - 50 kHz bandwidth, 1-10 W
140-5048-303: UHF Range 3, 406.1125-470.000 MHz, 6.25 - 50 kHz bandwidth, 1-10 W – Dual RF Ports
140-5048-502: UHF Range 5, 450.000-511.975 MHz, 6.25 - 50 kHz bandwidth, 1-10 W
140-5048-503: UHF Range 5, 450.000-511.975 MHz, 6.25 - 50 kHz bandwidth, 1-10 W – Dual RF Ports
140-5098-304: PCS, 880.000-902.000 MHz, 12.5 - 100 kHz bandwidth, 1-8 W
140-5098-305: PCS, 880.000-902.000 MHz, 12.5 - 100 kHz bandwidth, 1-8 W – Dual RF Ports
140-5098-504: ISM, 928.000-960,000 MHz, 12.5 - 100 kHz bandwidth, 1-8 W
140-5098-505: ISM, 928.000-960,000 MHz, 12.5 - 100 kHz bandwidth, 1-8 W – Dual RF Ports
European, Australian, and New Zealand Compliant Models (ETSI AS/NZ)
140-5018-600: VHF, 142.000-174.000 MHz, 6.25 - 50 kHz bandwidth, 1-10 W
140-5048-601: VHF, 142.000-174.000 MHz, 6.25 - 50 kHz bandwidth, 1-10 W – Dual RF Ports
140-5048-400: UHF Range 3, 406.1125-470.000 MHz, 6.25 - 50 kHz bandwidth, 1-10 W
140-5048-401: UHF Range 3, 406.1125-470.000 MHz, 6.25 - 50 kHz bandwidth, 1-10 W – Dual RF Ports
140-5048-600: UHF Range 5, 450.000-511.975 MHz, 6.25 - 50 kHz bandwidth, 1-10 W
140-5048-601: UHF Range 5, 450.000-511.975 MHz, 6.25 - 50 kHz bandwidth, 1-10 W – Dual RF Ports
To Next Page
Loading...
Need help?
General