Cal Amp VIPER SC+ 100 series User Manual

Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C | Page 45
Figure 30 – Radio Settings – CWID
CWID
CWID
If CWID is enabled, the Viper will broadcast the specified CWID; if disabled, the Viper will not. The default setting is
Disabled.
CWID Call Sign
This is the CWID or “call sign” to be broadcast if CWID is enabled.
CWID Interval
This is the time interval, in minutes, after which the CWID will be broadcast.
Save — Click Save to save any changes you have made. See Note below.
Cancel — Click Cancel to cancel any changes you may have made to any of the settings in this tab.

Cal Amp VIPER SC+ 100 series Specifications

General

Brand	Cal Amp
Model	VIPER SC+ 100 series
Category	Network Router
Language	English