Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C | Page 58
Figure 37 – Neighbor Node Detail window
– RF IP Address and Ethernet IP Address. This Neighbor Discovery module uses this information to build the routing
table. VLAN IDs (if applicable) are displayed in parentheses:
– RSSI (dBm). The RSSI is logged for all units that are only one (1) hop away. For units that are more than one hop
away or unreachable, the RSSI is not logged.
Route to Neighboring Vipers
– Hop Count and Next Hop. Indicates the route by which the remote unit can be reached. When the Hop Count is
one (1), the device can be reached directly. When the Hop Count is more than one (1), it can be reached by passing
through another Viper, as identified by the Next Hop.
To Next Page
Loading...
Need help?
General