cnPilot Enterprise AP User Guide CAMBIUM NETWORKS
Access to the network can be controlled based on traffic type and MAC address
using features such as WLAN and Port Access Control (ACL), DNS based whitelist
and blacklist, and DoS attack prevention
Provides several troubleshooting tools such as Packet Capture, WiFi Analyzer, and
Connectivity Tests.
Supports single hop mesh.
Supports roaming protocols such as 802.11r (cnPilot E400 only), OKC and Pre-auth
Supports Protected Management Frame for cnPilot E400 only (802.11w).
Support Band Steering feature which enables improvement in capacity and
throughput.
DEFAULT SETTINGS
The E400 Access Point is setup to obtain its IP address from a DHCP server. A default IP address of
192.168.0.1 will be used if an IP address is not obtained from DHCP. The default username and
password for CLI as well as GUI (http/https) access are admin / admin.
Note
The default IP address for ePMP 1000 Hotspot is 192.168.0.2.
LED STATUS
The E400 Access Point has two dual color LEDs. The power LED will glow Orange as the AP boots
up, and turn Green once it has booted up successfully. The network/status LED will glow Orange if
the connection to cnMaestro controller/manager is down, and Green once the AP is connected
successfully to cnMaestro.
Table 1: ePMP 1000 Hotspot LED Status
To Next Page
Loading...
