Cambium cnPilot E400 - Page 20

cnPilot Enterprise AP User Guide CAMBIUM NETWORKS
20
Cambium ID
Cambium-ID used for provisioning cnMaestro (Cambium
Remote Management) of this device.
─
Cambium
Password
Password used for onboarding the device to cnMaestro.
─
SNMP
V2 RO
Community
SNMP v2c read-only community string
─
V2 RW
Community
SNMP v2c read-write community string
─
V3 Username
SNMP v3 username
─
V3 Password
SNMP v3 password
─
Auth
Choose MD5 or sha
MD5
Access
Choose RO or RW
RO
Encryption
Choose ON or OFF
ON
You can configure the above parameters through the UI or CLI.
In the UI
1. Navigate to the Configuration > System tab. The following fields are displayed in
Management:
a. Enter the admin password of the device in the Admin Password text box.
b. Enable the Telnet checkbox to enable telnet access to the device CLI.
c. Enable the SSH checkbox to enable ssh access to the device CLI.
d. Enable the HTTP checkbox to enable HTTP access to the device UI.
e. Enable the HTTPS checkbox to enable HTTPS access to the device UI.
f. Under cnMaestro, enable Remote Management to support for Cambium Remote
Management of this device.
g. Enter the URL for cnMaestro in the cnMaestro URL text box.
h. Enter the Cambium ID of the user in the Cambium ID text box.
i. Enter the Onboarding Key in the Onboarding Key text box.
j. Enter the SNMP v2c read-only community string in the V2 RO community text box.
k. Enter the SNMP v2c read-write community string in the V2 RW community text box.
l. Enter the SNMP V3 username in the V3 Username text box.
m. Enter the SNMP V3 password in the V3 Password text box.
n. Choose MD5 or SHA from the Auth drop-down list.
o. Choose RO or RW from the Access drop-down list.
p. Choose ON or OFF from the Encryption drop-down list.
2. Click Save.