Cambium cnPilot E400 - Page 33

cnPilot Enterprise AP User Guide CAMBIUM NETWORKS
33
Attempts
Number of attempts before a request is given up.
─
Accounting Mode
start-stop:
Start-interim-stop:
None:
Server Pool Mode
Load Balance: Load balance requests equally among
configured servers.
Failover: Move down server list when earlier servers
are unreachable.
─
NAS Identifier
NAS-Identifier attribute to use in request packets.
Defaults to system name.
─
Interim Update
Interval
Interval for accounting interim stats update (60-65535).
120
You can configure the above parameters through the UI or CLI.
In the UI
1. Navigate to the Configure > WLAN > RADIUS Servers tab. The following fields are displayed:
a. Enter the IP address of the host for the authentication server in the host textbox.
b. Enter the shared key for this host in the Shared textbox.
c. Enter the Port in the Port textbox.
d. Enter the time in seconds of each request attempt in Timeout textbox.
e. Enter the number of attempts before a request is given up in the Attempts textbox.
f. Enter the IP address of the host for the accounting server in the host textbox.
g. Enter the shared key for this host in the Shared textbox.
h. Enter the Port in the Port textbox.
i. Enter the time in seconds of each request attempt in Timeout textbox.
j. Enter the number of attempts before a request is given up in the Attempts textbox.
k. Select any one of the Server Pool Mode:
 Load Balance
 Failover
l. Enter the interval for accounting interim stats update (60-65535) in the Interim
Update Interval textbox.
m. Enter the NAS identifier in the NAS Identifier textbox.
n. Select the Dynamic Auth checkbox to configure dynamic authorization for
wireless clients.
2. Click Save.