Cambium cnPilot E400 - Page 41

cnPilot Enterprise AP User Guide CAMBIUM NETWORKS
41
 Redirect User to External URL
 Redirect user to Original URL
Success
message
The message to be displayed in the login page
after successful authentication.
─
Session
Timeout
Administrator can configure a limited session time
for each session after which a re-login will be
enforced.
─
Inactivity
Timeout
Administrator can also configure an inactivity time
for deleting those clients which went away without
doing a proper guest access logout and free up the
consumed resources by that client. Such a
configuration is very helpful for public hotspots
where free network is provided and clients go
away without doing a logout.
─
The RADIUS server configuration is used for RADIUS access type guest access and one can also
enable RADIUS accounting for the guest access clients.
You can configure the above parameters through the UI or CLI.
In the UI
1. Navigate to the Configure > WLAN > Guest Access tab. The following fields are displayed:
a. Select Enable checkbox to enable guest access feature.
b. Choose the Access Policy as Click through or Radius.
c. Choose the Redirect Mode as HTTP or HTTPS.
d. Choose the login page to be on device login page or an external URL.
e. Enter the title to appear in the splash page in the Title textbox.
f. Enter the content to appear in the splash page in the Contents textbox.
g. Enter the terms and conditions to appear in the splash page in the Terms textbox.
h. Enter the success message to appear in the Success Message textbox.
i. Enter the session timeout in seconds in the Session Timeout textbox.
j. Enter the inactivity timeout in seconds in the Inactivity Timeout textbox.
2. Click Save.
To configure the whitelist parameter:
1. Enter the IP address or the domain name of the permitted domain in the IP Address or
Domain Name textbox.
2. Click Save.