p. 20 - Manual FA01332-EN - 04/2019 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. - Original instructions
Light E1
For choosing the type of device connected to the output.
F18 Light E1 0 =Flashing light (Default)
1 = Cycle light
The light remains off if an automatic closing time is not set.
Automatic cls
It sets the time that must pass before the automatic closing is activated, once the opening travel end has been reached.
The function does not work if any of the safety devices trigger when an obstacle is detected, or after a total stop, or during a power outage.
F19 Automatic cls OFF (Default)
From 1 to 180 seconds
Pre-flashing time
It sets the early activation time before each maneuvers.
F21 Pre-flashing time OFF (Default)
From 1 to 10 seconds
Opening speed
It sets the opening speed (percentage of maximum speed).
The percentage values automatically adapt to the value entered in the function [TCN_FUNCTION_A1_Tipo_motore_Lunghezza_asta_FUNCTION_XX_BARRIERS_NAMES_Name_3Boom length].
F28 Opening speed from 60% to 100% (Default 70%)
Closing speed
Sets the closing speed (percentage of maximum speed).
The percentage values automatically adapt to the value entered in the function [TCN_FUNCTION_A1_Tipo_motore_Lunghezza_asta_FUNCTION_XX_BARRIERS_NAMES_Name_3Boom length].
F29 Closing speed from 60% to 100% (Default 50%)
Travel sensitivity
Adjusting the obstruction detection sensitivity during boom travel.
F34 Travel sensitivity
from 10% to 100% (Default) - 10% = maximum sensitivity - 100% = minimum sensitivity
RSE1
Configures the function to be performed by the board connected to the RSE1 connector.
F49 RSE1 OFF (Default)
1 = Combined
4 = Compass
Saving data
It saves user data, timings and configurations to the memory device (memory roll or USB key).
The function is displayed only when a USB memory stick is inserted into the USB port or when a memory roll is inserted into the control board.
F50 Saving data OFF (Default)
ON
Data reading
It uploads user data, timings and configurations from the memory device (memory roll or USB key).
The function is displayed only when a USB memory stick is inserted into the USB port or when a memory roll is inserted into the control board.
F51 Data reading
To Next Page
Loading...
