p. 21 - Manual FA01332-EN - 04/2019 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. - Original instructions
Transferring MASTER-SLAVE parameters
It enables to share the parameters programmed on the Master barrier with the Slave barrier.
This only appears if the F49 function is set to Paired or Alternate.
F52 Transferring MASTER-SLAVE
parameters
OFF (Default)
ON
Opening direction
Set the boom opening direction.
F54 Opening direction 0 = To the left (Default)
1 = To the right
CRP address
It assigns a unique identification code (CRP address) to the control board. The function is necessary if there are more operators connected by CRP.
F56 CRP address from 1 to 255
RSE speed
Sets the remote connection system communication speed on the RSE1 port.
F63 RSE speed 0 = 1200 bps
1 = 2400 bps
2 = 4800 bps
3 = 9600 bps
4 = 14400 bps
5 = 19200 bps
6 = 38400 bps (Default)
7 = 57600 bps
8 = 115200 bps
FCA FCC warnings
Configure the method with which the FCA and FCC outputs report the boom status.
F70 FCA FCC warnings OFF
1 = Impulse
When the boom reaches the travel end (while opening or closing), the FCA-CM1 or
FCC-CM2 contact closes for one second.
2 = Steady
When the boom reaches the travel end (while opening or closing), the FCA-CM1 or
FCC-CM2 contact closes and remains closed.
3 = Custom
The FCA-CM1 contact is closed with the boom in the open travel end position and
during the opening maneuver. The FCC-CM2 contact is closed with the boom in the
closed travel end position and during the closing maneuver.
Opening counter
With the function active, it is possible to send a series of opening commands corresponding to the number of vehicles which have to be authorized to pass through
the gate. The function can only be operated by control devices connected to the contact 2-3. The input to which the magnetic contact on which the loop that counts
the vehicles in transit is connected must be programmed to operate in C5/C9/C10 mode; at the end of the count the passage is closed.
F75 Opening counter OFF (Default)
ON
Boom drop-away detection
It activate the contact on the ARM terminal block for detecting the boom drop-away.
F78 Boom drop-away detection Deactivated (default)
Activated
To Next Page
Loading...
