p. 4 - Manual FA00943-EN - 01/2018 - © CAME S.p.A. - Translation of the original instructions
that is compliant with the installation rules. It should completely cut off the power supply
according to category III surcharge conditions. • If the control panel is used for automa-
ting guided parts in residential settings, permanently fit the entrapment-hazard-warning
signage, so that it is clearly visible or close enough to all command and control devices.
After installing, make sure that the operator is properly adjusted and that the guided part,
in case it touches any object that is 50 mm high off the ground, inverts its movement or
that the object may easily be removed (for operators that have built-in anti-entrapment
systems that depend on coming into contact with the lower edge of the guided part). Also
make sure that the guided part does not extend onto any public pedestrian passages or
onto the street. • Store this manual inside the technical folder, along with the installation
manuals of the other devices in the system. Remember to hand over to the end users all
the operating manuals of the products that make up the final machinery.
To Next Page
Loading...
