CAME ZR24N - Safety Device Configuration; Connecting Safety Devices (Safety Test)

C7 TS10
11
1 2 7 C1
10 2 TX C
+
-
NC
RX
TX 2
TX 2
-
TX
DELTA-S DIR
C7 TS10
11
1 2 7 C1
+ -NOCNC
RX
TX -
+-
TX
DELTA
p. 14 - Manual FA00943-EN - 01/2018 - © CAME S.p.A. - Translation of the original instructions
Connecting the safety devices (i.e. the safety test)
At each opening and closing command, the control board checks the e cacy of the safety devices (such as, photocells).
Any anomalies will inhibit all commands.
For this type of connection, enable the function by setting DIP-switch 3 to ON.