Campbell CR6 - Syntax

Syntax for the powerup.ini file and available options follow.
8.8.1 Syntax
Syntax for powerup.ini is:
Command,File,Device
where,
l Command is one of the numeric commands in the following table.
l File is the accompanying operating system or user program file.
l Device is the data logger memory drive to which the accompanying operating system or
user program file is copied (usually CPU). If left blank or with an invalid option, default
device will be CPU. Use the same drive designation as the transporting external device if
the preference is to not copy the file.
WARNING:
Uploading a program, installing a data logger OS, or formatting a drive may result in data
loss. Depending on several factors, the data logger may also become incapacitated for a time.
It is recommended that you retrieve data from the data logger and back up your programs
before sending a powerup.ini file; otherwise, data may be lost. To collect data using
LoggerNet, connect to your data logger and click Collect Now . To backup your data
logger, connect to it in Device Configuration Utility, click the Backup menu and select
Backup Datalogger.
Table 8-2: Powerup.ini commands
Command Action Details
1
Run always,
preserve data
Copies a program file to a drive and sets the program to both
Run Now and Run on Power Up. Data on a memory card from
the previously running program will be preserved if table
structures have not changed.
2
Run on
power up
Copies a program file to a drive and sets the program to Run
Always unless command 6 or 14 is used to set a separate Run
Now program.
5 Format Formats a drive.
6
Run now,
preserve data
Copies a program file to a drive and sets the program to Run
Now. Data on a memory card from the previously running
program will be preserved if table structures have not changed.
8. CR6 maintenance 124