Campbell CR6 - Powersource; Processtime; Progerrors; Progname

10.2.35 PowerSource
Primary source of data logger power. Updates when background calibration executes.
l String data type
10.2.36 ProcessTime
Processing time (μs) of the last scan. Time is measured from the end of the EndScan instruction
(after the measurement event is set) to the beginning of the EndScan (before the wait for the
measurement event begins) for the subsequent scan. Calculated on-the-fly. Updated at the
conclusion of scan processing, prior to waiting for the next scan.
10.2.37 ProgErrors
Number of compile or runtime errors for the running program. Updated after compile.
10.2.38 ProgName
Name of current (running) program; updates at startup.
l String data type
10.2.39 ProgSignature
Signature of the running CRBasic program including comments. Does not change with
operating-system changes. Updates after compiling the program.
10.2.40 RecNum
Record number increments when the Status Table is requested by support software. Range = 0 to
2
32
.
l Long data type
10.2.41 RevBoard
Electronics board revision in the form xxx.yyy, where xxx = hardware revision number; yyy = clock
chip software revision. Stored in flash memory. Updated at startup.
l String data type
10. Information tables and settings (advanced) 170