10.2.49 SW12Volts
Status of switched, 12 VDC terminal. On/high (true) or off/low (false) Enter -1 to set to true. Enter
0 to set to false.Updates when the state changes.
l Boolean data type
10.2.50 SystemProcTime
Time (μs) required to process auto (background) calibration. Default is 0 until background
calibration runs.
10.2.51 TimeStamp
Scan-time that a record was generated.
l NSEC data type
10.2.52 VarOutOfBound
Number of attempts to write to an array outside of the declared size. The write does not occur.
Indicates a CRBasic program error. If an array is used in a loop or expression, the pre-compiler
and compiler do not check to see if an array is accessed out-of-bounds (i.e., accessing an array
with a variable index such as arr(index) = arr(index–1), where index is a variable). Updated at
runtime when the error occurs. Enter 0 to reset.
10.2.53 WatchdogErrors
Number of watchdog errors that have occurred while running this program. Resets automatically
when a new program is compiled. Enter 0 to reset. Updated at startup and at occurrence.
10.2.54 WiFiUpdateReq
Shows if WiFi operating system update is available. Update available (true) or not (false).
Updates when state changes.
l Boolean data type
10.3 CPIStatus system information
The CPIStatus table is automatically created when a program uses the CPI bus. View the
CPIStatus table by connecting the data logger to your computer (see Making the software
connection (p. 43) for more information).
10. Information tables and settings (advanced) 172
To Next Page
Loading...
