Campbell CR6 - Radiochanmask; Radioenable; Radiohopseq; Radiomac

10.4.73.2 RadioChanMask
The channel mask allows channels to be selectively enabled or disabled. This allows you to avoid
using frequencies that experience unacceptable levels of RF interference.
l String data type
Where to find:
l Settings Editor tab in Device Configuration Utility: Radio > Radio Channel Mask
10.4.73.3 RadioEnable
Global control for the internal radio module.
Where to find:
l Settings Editor tab in Device Configuration Utility: Radio > Radio Enable
10.4.73.4 RadioHopSeq
Specifies the radio channel hop sequence. This setting must match in all radios in the same RF
network. This setting can also be used to prevent radios in one RF network from listening to
transmissions of another.
l Long data type
Where to find:
l Settings Editor tab in Device Configuration Utility: Radio > RFHop Sequence
10.4.73.5 RadioMAC
Radio serial number.
l String data type
l Read only
Where to find:
l Settings Editor tab in Device Configuration Utility: Radio > Radio MACAddress
10.4.73.6 RadioModel
Reports the model of the internal radio module.
l String data type
l Read only
10. Information tables and settings (advanced) 189