10.4.74.13 RadioMinPacket
Determines the minimum number of bytes in the packets. Throughput can be enhanced when
packet sizes are optimized. In Point-to-Point mode, the Max and Min Packet Settings will not
have material impact on throughput unless 115.2 KBaud is desired. However, this may have an
impact on latency.
For example, if small amounts of data is sent and large packet sizes are selected, there would be
a certain amount of time "wasted" between each packet. The default settings for Max packet size,
Min packet size and RF Data Rate are 8, 9, and Normal RF Data Rate, respectively. In MultiPoint
networks, the Max Packet Size and Min Packet Size must be set identically in all transceivers.
l Long data type
Where to find:
l Settings Editor tab in Device Configuration Utility: RF451 > Min Packet Size
10.4.74.14 RadioMMSync
This setting is reserved for applications, in both Point-to-Point and MultiPoint modes, with
concentrations of Master units where it is necessary to reduce interference between the Masters.
l Long data type
Where to find:
l Settings Editor tab in Device Configuration Utility: RF451 > MultiMaster Sync
10.4.74.15 RadioModOS
Radio firmware version. This setting is available in dataloggers with integrated RF modules.
l String data type
l Read only
Where to find:
l Settings Editor tab in Device Configuration Utility: RF451 > RF451 iBus Module OS
10.4.74.16 RadioModuleVer
Radio hardware version.
l Long data type
l Read only
10. Information tables and settings (advanced) 198
To Next Page
Loading...
