Campbell CR6 - Tlspassword; Tlsstatus; Udpbroadcastfilter; Usbenumerate

10.4.65 TLSPassword
This setting specifies the password that will be used to decrypt the TLS Private Key setting.
l String data type
10.4.66 TLSStatus
Reports the current status of the data logger TLS network stack.
l String data type
l Read only
10.4.67 UDPBroadcastFilter
Set to one if all broadcast IP packets should be filtered from IP interfaces. Do not set this if you
use the IP discovery feature of the device configuration utility or of LoggerLink. If this is set, the
data logger will fail to respond to the broadcast requests.
Default = 0.
10.4.68 USBEnumerate
Controls the behavior of the data logger when its USB connector is plugged into the computer. If
set to a value of one, the data logger will use its own serial number for identification in the USB
enumeration. If set to a value of zero (the default), the data logger will use a fixed serial number
in the USB enumeration. This behavior controls whether the computer will allocate a new virtual
serial port for the data logger USB connection or will use a previously allocated (but not currently
used) virtual serial port. Default = 0.
10.4.69 USRDriveFree
Provides information on the available bytes for the USR drive.
l Read only
10.4.70 USRDriveSize
Specifies the size in bytes allocated for the USR: ram disk drive. This memory is allocated from the
memory that the data logger would normally use to store its compiled program or RAM based
data tables. If this setting is too large, some programs may not be able to compile on the data
logger.
Setting the USR: Drive Size setting will force the data logger to recompile its program and may
result in the loss of data.
10. Information tables and settings (advanced) 187