10.3.6 TxErrMax
Reports the maximum number of transmit errors. Enter 0 to reset.
10.3.7 FrameErr (frame errors)
Reports how many times a frame has an error. Enter 0 to reset.
10.3.8 ModuleInfo array
Reports:CDM Type, Serial Number, Device Name, CPI Address, Activity.
l String data type
l Read only
Possible responses and meanings in the Activity field are below:
l Active:The module is connected to the CPI bus and is making measurements according to
the data logger program.
l Offline: The module was present after startup but is no longer responding.
l Unused: The module is or was connected and powered but is not included in the data
logger program.
l Wait Config: The module has not yet responded to a data logger attempts to configure it.
l Config Fail: The module could not be configured. A configuration error message is
appended to this response.
10.4 Settings
Settings can be accessed from the LoggerNet Connect Screen Datalogger > Setting Editor, or
using Device Configuration Utility Settings Editor tab. Settings are organized in tabs and can be
searched for.
Most Settings are read/write and of a numeric data type unless noted.
Settings may be accessed programatically using SetSetting() or Tablename.Fieldname
syntax. For example: Variable = Settings.Fieldname. For more information
see:https://www.campbellsci.com/blog/programmatically-access-stored-data-values.
10. Information tables and settings (advanced) 174
To Next Page
Loading...
