10.2.42 RunSignature
Signature of the running binary (compiled) program. Value is independent of comments or non-
functional changes. Often changes with operating-system changes. Updates after compiling and
before running the program.
10.2.43 SerialNumber
CR6 serial number assigned by the factory when the data logger was calibrated. Stored in flash
memory. Updated at startup.
10.2.44 SkippedScan
Number of skipped program scans (see Checking station status (p. 128) for more information)
that have occurred while running the CRBasic program. Does not include scans intentionally
skipped as may occur with the use of ExitScan and Do / Loop instructions. Updated when
they occur. Enter 0 to reset.
10.2.45 SkippedSystemScan
Number of scans skipped in the background calibration. Enter 0 to reset. See LastSystemScan,
MaxSystemProcTime, and SystemProcTime.
10.2.46 StartTime
Time (date and time) the CRBasic program started. Updates at beginning of program compile.
l NSEC data type
10.2.47 StartUpCode
Indicates how the running program was compiled. Updated at startup. 65 = Run on powerup is
running and normal powerup occurred.
10.2.48 StationName
Station name stored in flash memory. This is not the same name as that is entered into your data
logger support software. This station name can be sampled into a data table, but it is not the
name that appears in data file headers. Updated at startup or when the name is changed. This
value is read-only if the data logger is currently running a program with a CardOut()
instruction.
l String data type
10. Information tables and settings (advanced) 171
To Next Page
Loading...
