CANNON Instrument Company | Initial Software Settings
Note: To enhance the readability of graph data when the Autoscaling option is
not used, set the numbers so that the highest graph value is slightly above the
maximum anticipated values for the test.
10. Set Bath Temperature:
a. Click on Bath from the tab options on the Instrument Setup menu.
b. Enter the desired temperature (between +25 °C and -40 °C).
Enable Temperature Control
The TE-BBR will not control temperature unless the Enable Temperature Control option is turned
on. When temperature control is enabled, the Enable option on the Setup menu will have a check
mark in front of it.
To enable temperature control, select Setup from the Main Menu and click on Enable
Temperature Control.
Note: Temperature Control is disabled when the BBR is turned off. If the
software application is exited but the BBR remains on, the Enable Temperature
Control option will retain its previous setting when the BBR is restarted.
Disable Temperature Control
To disable temperature control, repeat the process used to enable temperature control (see above).
When you click on Enable Temperature Control, the check mark is removed to indicate that
temperature control is no longer enabled.
To Next Page
Loading...