Figure 6: Stirring Bar ....................................................................................................................... 13
Figure 7: Bubble Level for Load Frame ............................................................................................. 13
Figure 8: Electrical Connections – Load Frame Figure 9: Electrical Connections – Control Unit ... 15
Figure 10: Air/Water Heat Exchanger Power Connections ............................................................... 15
Figure 11: TE-BBR Serial Connections ............................................................................................. 16
Figure 12: Dry Air/Nitrogen Connections – Control Unit ................................................................. 16
Figure 13: Air/Water Heat Exchanger Reservoir .............................................................................. 19
Figure 16: Instrument Setup ........................................................................................................... 23
Figure 17: Load Unit Calibration.......................................................................................................27
Figure 18: Placing Weight with Forceps .......................................................................................... 28
Figure 19: Toolbar Options .............................................................................................................. 33
Figure 20: Mold Specimen Diagram ................................................................................................ 36
Figure 21: Graph of Test Results ..................................................................................................... 43
Figure 22: Report View of Test Results ........................................................................................... 44
Figure 14: Remove Exchanger Tubing Connection .......................................................................... 47
Figure 15: Exchanger with Housing Removed ................................................................................. 48
Figure 23: Keyway Diagram ............................................................................................................. 51
Figure 24: Bubble Level ...................................................................................................................53
Figure 25: Diagram A (new) Figure 26: Diagram B (old).............................. 59
Figure 27: TE-BBR Capacitor ........................................................................................................... 60
Figure 28: Terminal Connections .................................................................................................... 60
Figure 29: Load Cylinder Air Line Connections ............................................................................... 63
Figure 30: Report View .................................................................................................................... 73
Figure 31: Graph View ..................................................................................................................... 74
Figure 32: TE-BBR Motor Stirrer/Plate and AC Power Connector ..................................................... 75
Figure 33: Motor Stirrer Wiring Diagram ......................................................................................... 76
Figure 34: Supported Load Frame ...................................................................................................78
Figure 35: Load Frame Supports ......................................................................................................78
Figure 36: Crack Seal Option Installation (note probe location and cut-out area for beam placement)
....................................................................................................................................................... 79
Figure 37: Crack Seal Option Installation with Adaptor for Normal Asphalt Beam BBR Operation .. 79
List of Tables
Table 1: CANNON TE-BBR Specifications ........................................................................................ 7
Table 2: TE-BBR Part numbers ......................................................................................................... 9
To Next Page
Loading...