TE-BBR Instruction and Operation Manual
10. Return the Load Frame and bath fluid to the TE-BBR bath per safety-approved procedures. Refer to
section Prepare the Temperature Bath for instructions. The Crack Seal Option installation is
complete.
Do NOT use the new Crack Seal thick beam and/or the Crack Seal thin beam adapter assembly when the
Support Adapter (upper member) is installed. The new components are only used for
calibration/verification for the Crack Seal test. These new components are designed to rest on the Crack
Seal Support (lower member).
To calibrate the TE-BBR for the normal asphalt test, use the thick and thin beams provided with the
instrument.
To Next Page
Loading...