Getting
Started
:St;~igiI;1r;@'i'eil:ie.Ll\ati;Dig'ii\tb\~meigWi~t'mS!Ug.g;1~
.....
The camcorder can be powered with a battery pack or directly using the compact power
adapter. Charge the battery pack before use.
1.
Turn·off
the
camcorder.
2.
Attach
the
battery
pack
to
the
camcorder.
• Open the LCD panel.
• Slide
in
the connector end
of
the battery
in
the direction
of
the arrow and press it
gently until it clicks.
3.
Connect
the
power
cord
to
the
compact
power
adapter.
4.
Plug the
power
cord
into
a
power
outlet.
5.
Connect
the
compact
power
adapter
to
the
camcorder's
DC
IN
terminal.
• The
CHG.
(charge) indicator starts
flashing. The indicator will stay
on
when
Remove the battery terminal cover
the charging is completed. before attaching the battery
•
You
can also use the compact power
adapter without attaching a battery pack.
• When the compact power adapter
is
connected, even if a battery
is
attached its
power will not be consumed.
Once the battery is fully charged:
1.
Disconnect
the
compact
power
adapter
from
the
camcorder.
2.
Unplug the
power
cord
from
the
power
outlet
and the
compact
power
adapter.
To
remove the battery pack:
Slide
down
to
release
the
battery
pack, and
pull
out
the
battery pack
holding
it
from
the
ridge
on
its
bottom
part.
Charging,
Recording
and Playback Times
with
the
BP-208 Battery Pack
The charging time of the BP-208 battery pack is 165 min.
The following recording and playback times are approximate and vary according to the
charging, recording or playback conditions.
-
17
To Next Page
Loading...
