To
use the still images functions, you will need to set [STILL IMAGES] to [ON]
beforehand
(CD
11).
I
To
change the operating mode, refer to About the Operating Modes
(CD
11).
1.
Open
the
LCD panel and the lens
cover
(move
the
lens
cover
switch
down
to
CS;).
2.
Press
:111,lllllli!lllliill~11
halfway.
Once the focus is automatically adjusted,
o will turn green and one or more AF
frames appear.
3.
Press fully.
The DISC access indicator will flash as
the image
is
being recorded.
@ ®
J. J
....
26
Avoid the following actions while the disc access display
~
@ appears and while
the DISC access indicator
is
on
or flashing. Failing to do so may result
in
permanent data loss.
- Do not subject the camcorder to vibrations or strong impacts.
- Do not open the disc cover and do not remove the disc.
-
Do
not disconnect the power source or turn off the camcorder.
-
Do
not change the operating mode.
If the subject is not suitable for autofocus, 0 turns yellow. Keep
l.ll~lil'lilllll
pressed halfway and adjust the focus manually with the multi selector
(~~).
To Next Page
Loading...
