Chapter 1
1-25
T-1-9
*1: Available only if ManageRemainRoll is On.
*2: Available only if Width Detection is set to Off.
*3: Available after Auto(Advanced) in Head Posi. Adj. has been used once.
*4: Available when you have specified Feed Priority > Adj. Priority > Automatic or Print Quality.
*5: Available when you have specified Feed Priority > Adj. Priority > Automatic or Print Length.
*6: Displayed if a sheet is loaded in the printer.
*7: Not shown if you have set IPv4 Mode to Manual.
*8: Not shown if you have set NetWare to Off.
*9: Not displayed if IPv6 Support is Off.
*10: Not shown if you have set Auto Detect to On.
*11: Print Anyway is displayed when a job being held is selected.
*12: Viewing and configuration is possible for administrators, and only viewing for other users.
*13: Viewing and configuration is possible for administrators only.
*14: Follows the setting in Date Format.
*15: Displayed only when the Media Take-up Unit is attached.
*16: Available if: Use Take-up Reel is Enable, roll paper is loaded, and you have not executed Auto Feed for the loaded roll.
*17: Available when Use Take-up Reel is Enable.
*18: Leading edge is not available as a setting option in the Paper Detailed Settings dialog box of the printer driver.
*19: Default setting for the time to enter the power save mode/sleep mode is recommended.
First Level Second Level Third Level Fourth Level Fifth Level
[System Setup] [Nozzle Check] [Frequency] [Standard]*
[1 page]
[Warning] [Off]*
[On]
[CarriageScanWidth] [Automatic]*
[Fixed]
[Use RemoteUI]*12 [On]*
[Off]
[Reset PaprSetngs]*12
[Erase HDD Data]*12 [High Speed]
[Secure High Spd.]
[Secure]
[Output Method] [Print]*
[Print (Auto Del)]
[Save: Box XX]
[Print After Recv] [Off]*
[On]
[Common Box Set.]*12 [Print]
[Print (Auto Del)]*
[Show Job Log] [Off]
[On]
[Take-up Reel] [Use Take-up Reel] [Disable]*
[Enable]
[Auto Feed]*16
[Skip Take-up Err]*17 [Off]*
[On]
[Prep.MovePrinter] [Level 1]
[Level 2]
[Level 3]
[Admin. Menu]*12 [Change Password]*13
[Init.Admin.Pswd]*13
[Printer Info] [Paper Info]
[Ink Info]
[Head Info]
[System Info]
[Error Log]
[Other Counter]