1
On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to
select the Paper tab (
).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button. The Paper Menu is displayed.
3
Press â–² or â–¼ to select Paper Details, and then press the OK button.
4
Press â–² or â–¼ to select the type of paper, and then press the OK button.
5
Press â–² or â–¼ to select Cutting Mode, and then press the OK button.
6
Press â–² or â–¼ to select Eject, and then press the OK button.
7
Print the job.
When printing is finished, the printer will stop without cutting.
8
Holding the printed document to prevent it from dropping,
press the Cut button to cut the roll.
Manual (when using media that cannot be cut with the Cutter Unit )
Note
• Once the following step has been performed, the procedure can be started from step 8 the next time.
• Printing the second and subsequent times
• Printing after replacing with the same type of paper
iPF8400SE
Specifying the Cutting Method for Rolls
User's Guide
Handling and Use of Paper Handling rolls
353
To Next Page
Loading...
Need help?
General