1
On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to
select the Paper tab (
).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button. The Paper Menu is displayed.
3
Press â–² or â–¼ to select Paper Details, and then press the OK button.
4
Press â–² or â–¼ to select the type of paper, and then press the OK button.
5
Press â–² or â–¼ to select Cutting Mode, and then press the OK button.
6
Press â–² or â–¼ to select Manual, and then press the OK button.
7
When "Perform the detection of paper leading edge?" is displayed, select Perform(recommend).
8
Print the job.
The printer stops advancing the paper after printing.
9
Press the Feed button.
Roll paper is fed to the specified cut position and then au-
tomatically stopped.
10
Cut the roll paper manually with scissors or the like.
11
Press the OK button.
After the roll is rewound, it stops automatically.
Specifying the Cutting Method for Rolls
iPF8400SE
User's Guide
Handling and Use of Paper Handling rolls
354
To Next Page
Loading...
Need help?
General