attempted the number of specified times but failed, or T5 time-over (60 sec.) has occurred.
##769 TX After transmitting PPS-EOP in ECM transmission, re-transmission of the procedure signal has been
attempted the number of specified times but failed.
##770 TX After transmitting EOR-NULL in ECM transmission, no significant signal has been received, and re-
transmission of the procedure signal has been attempted the number of specified times but failed.
##772 TX After transmitting EOR-NULL in ECM transmission, DCN has been received.
##773 TX After transmitting EOR-NULL in ECM transmission, re-transmission of the procedure signal has been
attempted the number of specified times but failed, or T5 time-over (60 sec.) has occurred.
##774 TX After transmitting EOR-NULL in ECM transmission, ERR has been received.
##775 TX After transmitting EOR-MPS in ECM transmission, no significant signal has been received, and re-
transmission of the procedure signal has been attempted the number of specified times but failed.
##777 TX After transmitting EOR-MPS in ECM transmission, DCN has been received.
##778 TX After transmitting EOR-MPS in ECM transmission, re-transmission of the procedure signal has been
attempted the number of specified times but failed, or T5 time-over (60 sec.) has occurred.
##779 TX After transmitting EOR-MPS in ECM transmission, ERR has been received.
##780 TX After transmitting EOR-EOM in ECM transmission, no significant signal has been received, and re-
transmission of the procedure signal has been attempted the number of specified times but failed.
##782 TX After transmitting EOR-EOM in ECM transmission, DCN has been received.
##783 TX After transmitting EOR-EOM in ECM transmission, re-transmission of the procedure signal has been
attempted the number of specified times but failed, or T5 time-over (60 sec.) has occurred.
##784 TX After transmitting EOR-EOM in ECM transmission, ERR has been received.
##785 TX After transmitting EOR-EOP in ECM transmission, no significant signal has been received, and re-
transmission of the procedure signal has been attempted the number of specified times but failed.
##787 TX After transmitting EOR-EOP in ECM transmission, DCN has been received.
##788 TX After transmitting EOR-EOP in ECM transmission, re-transmission of the procedure signal has been
attempted the number of specified times but failed, or T5 time-over (60 sec.) has occurred.
##789 TX After transmitting EOR-EOP in ECM transmission, ERR has been received.
##790 RX After receiving EOR-EOP in ECM reception, ERR has been transmitted.
##791 TX / RX During the ECM mode procedure, a signal other than a significant one has been received.
##792 RX In ECM reception, PPS-NULL between partial pages has not been detected.
##793 RX During high-speed signal reception in ECM, no effective frame has been detected, and a time-over has
occurred.
To Next Page
Loading...
