Canon Oce PlotWave 550 - Set the Maximum Folding Length

Set the maximum folding length
Introduction
The best maximum folding length differs for the various media densities, fold delivery
destinations and number of folds.
Use the recommended maximum folding length values listed below to prevent media jams and
guarantee the selected fold delivery destination.
Set the [Maximum sheet length for first fold]
1. Open Océ Express WebTools.
2. Open the [Configuration] - [Printer setup] tab.
3. Click on [Edit] in the [Finishing] section or click on the [Maximum sheet length for first fold]
setting.
4. Use the overview to fill in the maximum length.
Media density First fold - 1 fold
60 g/m
2
1220 mm / 48 inch
75 g/m
2
6000 mm / 236 inch
110 g/m
2
2500 mm / 98 inch
5. Click on [Ok] to confirm or [Cancel] to reject your entries.
Set the [Maximum sheet length for second fold]
1. Open Océ Express WebTools.
2. Open the [Configuration] - [Printer setup] tab.
3. Click on [Edit] in the [Finishing] section or click on the [Maximum sheet length for second
fold] setting.
4. Use the overview to fill in the maximum length.
Media density Stacker or Belts - 2 folds Stacker - 3 folds
60 g/m
2
1220 mm / 48 inch 1220 mm / 48 inch
75 g/m
2
2000 mm / 79 inch 2000 mm / 79 inch
110 g/m
2
1220 mm / 48 inch not possible
5. Click on [Ok] to confirm or [Cancel] to reject your entries.
Set the maximum folding length
Chapter 5 - Use the Folder
221