CanyCom CMX222 - Working; Inspecting Cutting Blade; Adjusting Cutting Height

-33-
Operation 4
Working
1. Push lock button to unlock cutting height
adjust lever.
Inspecting Cutting Blade
2. With lock button depressed, move cutting
height adjust lever to a desired position.
3. Release lock button to lock cutting height
adjust lever.
5321M-0403-010E
Lock Button
Inspect cutting blade before work. Refer to Cutting Blades (page 63) for inspection
procedure.
Adjusting Cutting Height
Cutting Height
Adjust Lever
5321M-0403-020E
• Cutting Height Range: 0mm - 180mm.
(CMX222)
0mm - 160mm
(CM223)
• Cutting rotary clutch cannot be engaged
when cutting height adjust lever is set
above 180mm for CMX222 or 160mm for
CM223.
• Cutting Height indicated on the side of the
adjust lever is for reference purpose only;
actual cutting height may vary due to the
condition of ground or brush, and other
factors.
NOTE