After Use Care
Cutting System
• Never place any part of body under cutting blade shield when cutting blade is
rotating.
• Do not allow bystanders to come near machine when cutting blade is rotating.
• Always stay on machine when performing this opeartion
• Never attempt to clean cutting system with cutting blade shield open. Stones or
rocks can be thrown and cause damage to surrounding properties or persons.
• Turn cutting rotary clutch to [ON] only when cleaning. Keep it in [OFF] position
all the other times.
1. Park machine.
2. Set cutting height to about 50mm.
3. Remove cap and connect hose. Run water
through hose.
4. Start engine.
5. Turn throttle lever to [ (fast)] to raise
engine speed.
6. Move cutting rotary clutch lever to [ON] to
rotate cutting blade to clean.
7. When cleaning is done, move cutting rotary
clutch lever to [OFF] to stop cutting blade.
• Do not set cutting height too low It may hit
ground.
NOTE
To Next Page
Loading...
