Drive Train
• Stop engine when servicing drive train.
• Allow machine to cool off before servicing. Engine and its ancillaries are very
hot after operation and may pose a burn hazard.
Tires
1. Park machine on a level ground.
2. Remove valve cap.
3. Check tire air pressure. If different from the
specied values, adjust pressure.
4. Put valve cap back in place.
• Inate tires to the specied pressure. Under- or over-ination causes uneven
wear or other damages to tires.
Tire Size Pressure KPa(kgf/cm
2
)
CMX222
Front TA 4.00-8 (2PR) 110 (1.1)
Rear 19×8.00-10 (4PR) 220 (2.2)
CM223
Front AGS 4.00-7 (4PR) 220 (2.2)
Rear 17X8.00-8 220 (2.2)
• Dispose of drained oil properly.
To Next Page
Loading...
