CanyCom CMX222 - Page 89

Troubleshooting
-80-
6
Area Malfunction Possible Cause Corrective Measure Ref.
Drive Train
Machine does not
move when drive lever
or pedal is operated.
Insufcient or
deteriorated HST uid.
→Add or change uid. Page 54
Parking brake is
applied
→Release the parking
brake.
V-belt is loose. →Adjust V-belt. Page 56
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Machine moves when
drive lever or pedal is
in neutral position.
HST is out of neutral. →Please contact
your CANYCOM
representative.
Transmission jumps
out of gear.
Transmission is not
positively shifted.
→Shift rmly.
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Machine does not turn
smoothly.
Tires are not properly
inated.
→Adjust tire pressure. Page 52
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Machine does not run
straight.
Tie-rod is not properly
adjusted.
→Please contact
your CANYCOM
representative.
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Brake
Brake or parking brake
does not work well, or
machine pulls to one
side when braked.
Brake is not proerly
adjusted.
→Adjust. Page 57
Brake is wet with water. →Apply brake a few
times to dry.
Other (other than the
above).
→Please contact
your CANYCOM
representative.
Chassis
Machine vibrates
abnormally.
Improperly inated
tires.
→Adjust tire pressure. Page 52
Other (other than the
above).
→Please contact
your CANYCOM
representative.