CanyCom CMX222 - Page 91

Troubleshooting
-82-
6
Area Malfunction Possible Cause Corrective Measure Ref.
Cutting
System
Cutting blade cuts into
ground.
Cutting height is too
low.
→Raise cutting height.
Machine turns too fast. →Turn slowly.
Work site has
undulations.
→Raise cutting height.
Cutting blade (knives
or stay) is bent.
→Replace.
Cutter load is too high.
Engine speed is too low. →Raise engine speed.
Driving speed is too
high.
→Drive slow.
Cut grass or vines
are tangled to cutting
blade axle.
→Untangle.