212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
2.3 INDICATOR SETUP REVIEW
The 212/212X indicator allows several operational parameters to be
reviewed and changed without performing the full setup and configuration
procedure.
Accessing Setup Review
1. With the indicator ON, press the key.
2. The indicator will respond by showing the FunCt= (Function) prompt
3. Press the F key.
4. The display will change to show Lt= xx. Note that XX is the current
LCD Light Sensor Reading and is not adjustable.
5. Press the key to return to the previous prompt.
6. To exit Setup Review, press the ENTER key to step through the
remaining prompts OR at anytime, cycle the power (press the
ON/OFF key twice).
Current LCD Light Sensor Reading (where XXX is the
current value) NOTE: This value is not adjustable.
Light Sensor Reading at which LCD Backlight will turn ON
Note that the LCD Backlight will turn OFF at the LSET=
value plus 10.
For example, if LSET= is 5, then the backlight will turn ON
when the LT= reading is 5 and turn OFF when the LT=
reading is 15.
If the setting displayed is acceptable, press the ENTER
key again to save it. Otherwise, using the numeric keys,
enter the new setting and then press the ENTER key to
save it and advance to the next prompt. Allowable
settings are 0 to 255.
NOTE: Use the same procedure as described in the Indicator Setup
section of this manual to make any changes to the following:
Time Format (12 or 24 hour)
Digital Output Control Enable/Disable and Settings
To Next Page
Loading...
Need help?
General
