Cardinal 212 Series - Serial Input;Output Configuration; Serial Port Settings

212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
Page 81
Serial Input/Output
Sio (Sio?)
With Sio (Sio?) displayed, press the ENTER key. The display will change
to show the current setting “nO”. To skip configuring the Sio (serial
input/output) and proceed to the Print? menu, press the ENTER key
again. To configure the Sio, press the numeric key 1/YES and then the
ENTER key. The display will change to the bAud= prompt.
bAUd= (Serial Port Baud Rate)
Press the ENTER key to show the current setting. If the setting displayed
is acceptable, press the ENTER key again to save it. Otherwise, use the
numeric keys to enter a new baud rate for the serial ports and then press
the ENTER key to save it. Allowable settings are:
12 = 1200 Baud
24 = 2400 Baud
48 = 4800 Baud
96 = 9600 Baud
19 = 19.2k Baud
38 = 38.4k Baud
76 = 76.8k Baud
Prty= (Serial Port Parity)
Press the ENTER key to show the current setting. If the setting displayed
is acceptable, press the ENTER key again to save it. Otherwise, using the
numeric keys enter the new setting and then press the ENTER key to
save it. Allowable settings are 0, 1, or 2.
0 = NONE (No Parity)
1 = Odd Parity
2 = Even Parity
bitS= (Serial Port Data Bits)
Press the ENTER key to show the current setting. If the setting displayed
is acceptable, press the ENTER key again to save it. Otherwise, using the
numeric keys enter the new setting and then press the ENTER key to
save it. Allowable settings are 7 or 8.
StoP= (Serial Port Stop Bits)
Press the ENTER key to show the current setting. If the setting displayed
is acceptable, press the ENTER key again to save it. Otherwise, using the
numeric keys enter the new setting and then press the ENTER key to
save it. Allowable settings are 1 or 2.