Cardinal 212 Series - Page 104

212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
Page 96
The next prompt is only displayed when D-Out = 1 or 11
P-BAL=
Print On Balance
The following prompts are only displayed when D-Out = 4 or 14
Fil-aa
Fill Auto Accumulate
Purge=
Number of Digital Fill Cycles before purging
feeder
p-wgt=
Purge Weight – The amount of material
contained in feeder before purge.
The next prompt is only displayed when Speed = 2
GATE=
Gate
The next prompts are only displayed when D-Out = 4 or 14
A-TRIM
Auto Trim
A-PRNT
Auto Print
DFCEND
DFC Ending Message DONE (if SPEED=2)
The next prompt will be displayed if D-Out = 1, 2, 3, 11, 12 or 13
A-HLD=
Auto-Hold
The following prompts are only displayed when A-HLD = 1 or 2
THRES=
Threshold
A-ACC=
Auto-Accumulate
BALTOL
Balance Tolerance
dFLt=
Digital Filtering
Cont1=
Continuous Output Serial Port 1 Enable/Disable
type=-
Continuous Output Format Selection
Cont2=
Continuous Output Serial Port 2 Enable/Disable
type=
Continuous Output Format Selection
SLEEP=
Sleep Mode Enable/Disable and Settings
A OFF=
Auto-Shutdown Enable/Disable and Settings
A cLr=
Auto Clear ID