212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
10. If you wish to check how much material is remaining on the scale,
switch to Load mode by pressing the LOAD/UNLOAD key.
NOTE: The displayed Unload weight will be lost when you do this
and cannot be done in the middle of a fill cycle. Press the
LOAD/UNLOAD key again to switch back to Unload mode before
starting the next cycle.
11. If you have a value set for PURGE above, the indicator will be counting
the number of fill cycles completed and once the purge count (PURGE
value) is reached, the purge weight (P-WGT) will be added to the trim
weight and flash PURGE FEEDER on the display. At this time, you would
need to manually purge your feeder into the last container.
To Next Page
Loading...