The ZERO/CLEAR key is used to zero the
weight display. Up to the selected limit of 4% or
100% of the scale’s capacity can be zeroed.
This limit is selected during the setup and
calibration of the indicator.
Note that the indicator will not respond to
pressing the ZERO/CLEAR key unless the
weight display is stable.
When displaying a Tare weight, pressing
the ZERO/CLEAR key will clear the Tare
value and set the display to Gross mode.
When an ID has been selected, the user
can erase that id by pressing the F key and
then ZERO/CLEAR key. The user will be
prompted to confirm and will need to press
YES or NO.
Pressing the ZERO/CLEAR key while
scrolling through the IDs using the RECALL
key will also prompt the user to confirm ID
erase.
Pressing the ZERO/CLEAR key while the
current IDs accumulator is being display will
prompt the user to clear this accumulator.
The user will be prompted to confirm and
will need to press YES or NO.
To Next Page
Loading...
Need help?
General
