212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
ACC= (Weight Accumulator Print Location)
Press the ENTER key to show the current setting for the location of
printing for the currently used accumulator.
For example, if an ID is selected, it will be that ID's accumulator. If no ID
is selected and Gross weight is displayed, it will be the Gross
accumulator. If no ID is selected and Net weight is displayed, it will be
the Net accumulator.
If the setting displayed is acceptable, press the ENTER key again to
save it. Otherwise, use the numeric keys to enter a new location and
then press ENTER to save it.
CrLF= (Carriage Return Line Feed) - Data Format Termination
Data transmitted from the serial I/O port can be terminated with a single
carriage return and either no line feed or a single line feed command.
Press the ENTER key to view the current setting. A "YES" displayed
means the data will be terminated with a carriage return AND a line feed.
A "no" displayed means the data will be terminated with a single carriage
return only.
If the setting displayed is acceptable, press the ENTER key again to save
it. Otherwise, using the numeric keys, 0/NO or 1/YES, enter the new
setting and then press the ENTER key to save it.
EoP= (End-Of-Print Line Feeds)
At the end of a data transmission to a printer, the indicator can transmit a
pre-selected number of line feed commands to space the paper in the
printer to the desired position for withdrawal or for the next print.
Press the ENTER key to view the current setting. If the displayed setting
is acceptable, press the ENTER key to save it. Otherwise, use the
numeric keys to enter the new the number of End-Of-Print linefeeds and
then press the ENTER key to save the new setting. Allowable settings
are: 0 through 99...
To Next Page
Loading...
Need help?
General
