9
WEIGHING UNITS
press the ENTER key to view the current setting. If the
setting shown in acceptable, press the ENTER key again
to save it, otherwise, press the 1, 2, 3, 4, 5 or 6 key to
select the new weighing units and then press the ENTER
key to save the new setting.
1 = Pounds Only 4=Kilograms/Pounds
2 = Kilograms Only 5=Ounces Only
3 = Pounds/Kilograms 6=Grams Only
CALIBRATION WEIGHT
press the ENTER key and enter the desired value of test
weight to be used. Make certain the scale platform is
empty and free of debris then place the test weight(s) on
the platform and press the ENTER key. The display will
then indicate segments in sequence.
remove the test weight(s) from the scale and press the
ENTER key. After a few moments the display will prompt
for the auto zero tracking limits.
ZERO TRACKING RANGE
press the ENTER key to view the current range of
automatic zero tracking range. If the value shown is
acceptable, press the ENTER key to save it otherwise
enter the new number of divisions of automatic zero
tracking range and press the ENTER key to save it.
Available settings are: 0, .5, 1, 2, 3, 4, 5, 6, 7, 8, and 9.
Entry of a “0” turns off the zero tracking feature.
4% ZERO RANGE
press the ENTER key to view the current setting for this
feature. If a YES is displayed, the push button zero and
zero tracking range features are limited to a maximum
range of 4% of the scale capacity. If a NO is shown the
push button zero and zero tracking range features will
operate up to the full capacity of the scale. Press the 1
key to change the setting to YES or the 0 key to change
the setting to NO then press the ENTER key to save the
setting.
POWER UP ZERO
press the ENTER key to view the current setting for this
feature. If YES is shown, the weight display will be reset
to zero automatically on power up but if NO is shown the
weight display will not be reset to zero. Pressing the 1
key will change the setting to YES while pressing the 0
key will change the setting to NO. Once the proper
setting is displayed, press the ENTER key to save it.
FILTERING
press the ENTER key to show the current setting of the
708’s filter: 0 = NO FILTERING
1 = MINIMAL FILTERING (sample rate = 2)
2 = MODERATE FILTERING (sample rate = 1)
3 = CUSTOM FILTERING
Press the ENTER key twice
to skip this step and proceed
to the Zero Tracking Range
OR
Unt=
Lod=
UnLd
trA=
trL=
PUO=
FLt=
To Next Page
Loading...
