Installation and Programming Guide 131
Arming and Disarming Your System
You may arm and disarm areas from a NXX-1820-keypad.
Only users with an authorized user code (Level 2 user) will be allowed to use the Aritech
Reliance XR alarm system. Users with no valid user code (Level 1 user) do not have access
as defined by EN 50131-3.
Lock Out On 3 Invalid Attempts
If an invalid PIN code is entered three times, the keypad will deny all log in attempts for 90
seconds. Attempts are counted from any method (e.g. keypad, app, or web page). You must
wait the full 90 seconds before trying again with the correct PIN. This is to prevent brute-
force attacks on guessing PIN codes.
Arm Your System In Away Mode
Enter a valid PIN code to unlock the screen.
Touch the Away or Away + button to arm your system in Away mode:
The icon will change to red when the alarm system is set in away mode.
If your system has multi-Area control enabled, the Away + button will be displayed.
A valid PIN code will need to be entered to determine what permissions they have; this
includes which Areas and at what time/day that user has access.
Arm Your System In Stay Mode
Enter a valid PIN code with Stay permissions to unlock the screen.
Touch the Stay or Stay + button to arm your system in Stay mode:
The icon will change to yellow when alarm system is set in Stay mode.
If your system has multi-Area control enabled, the Stay + button will be displayed.
A valid PIN code will need to be entered to determine what permissions they have, this
includes which Areas and at what time/day that user has access.
Arm Your System in Instant Stay Mode
Enter a valid PIN code with Stay permissions to unlock the screen.
To arm in Instant Stay mode, touch the Stay button two times until the icon is red and
displays “Instant”:
To Next Page
Loading...
