Installation and Programming Guide 133
Depending on how your system is programmed, the control room may receive the
corresponding event. Check with your control room to determine what action will be taken.
If silent alarm is enabled, then the keypad will not display any signs that the panic button
was pressed.
To cancel a SOS alarm – return to the home screen, touch the Status button and turn the
Area off.
Walk Test
1. Log in to panel web page.
2. Click Settings.
3. Click Walk Test.
4. Click Start.
5. Trigger each sensor by walking past PIRs, opening and closing reed switches,
pressing tamper buttons, etc. Siren will chirp multiple times for each zone triggered.
6. Click Stop.
7. Click History.
User Reporting
When enabled, quick arming/disarming from the keypad without a PIN code will report
user 98 to the Central Monitoring Station. SOS functions also report as user 98.
If the installer PIN is used to arm/disarm, user 256 is reported to the Central Monitoring
Station. On legacy NX keypads user 255 will appear in event history.
To Next Page
Loading...
