Carrier Aritech Reliance XR Series - Programming Instructions for Channels

114 Installation and Programming Guide
Example
In this example we have created two lists: Critical and Informational. This allows us to
selectively deliver event messages to different destinations.
We open up Event Lists and enter the name “Critical”. We tick Alarms, Alarm Restores,
Bypass and Bypass Restore, and AC Fail Reporting.
Then we click to Event List 2 and enter the name “Informational”. Tick Opening and Closing,
and Autotest Report.
Programming Instructions for Channels
Goal
Set up communication paths and destinations for delivering event messages.
Pre-conditions
1. Communicator must be programmed (see "Programming Instructions for
Communicator" on page 107).
2. Event Lists must be programmed (see "Programming Instructions for Event Lists" on
page 112).
3. If reporting to a control room, the panel must be provisioned in the UltraSync Portal.
The provisioning process sets the primary and secondary paths (IP/cellular), local path
fail detection, and server-based path monitoring settings.
Notes:
Area Account Number will take priority over Account Number entered here for Zone
events. If no Area Account Number is entered, then this number will be used instead.
Channel Group 1
Channel 1
Channel 4
Channel 6
Event List 1
Critical
Event
Menu 6.11.1.1 or 4
Channel Group 1
System / Area
Channel 4
Control Room 2
Event List = 1
Channel 6
Email
Event List = 2
Channel 1
Control Room 1
Event List = 1
Menu 18 – Channel Groups
Event sent to
Channel Group
Channel Group sends event
to every Channel it contains
Menu 5 – Channels
Each channel checks to see
if the event is on its Event
List, if yes it will attempt to
send, if not then it stops.
Menu 17 – Event Lists
Event List 2
Informational
Open & Closes
Autotest
Alarms
Bypass & Restore
AC Fail