118 Installation and Programming Guide
Notice that Channel 2 is not selected in Channel Group 1. The Aritech Reliance XR will
deliver to Channel 2 only if Channel 1 cannot be reached. If Channel 2 were included in
Channel Group 1, then the control room may receive duplicate messages.
Next
• Program your Areas and Zones.
Programming Instructions for Zone Reporting
Goal
Direct event messages (e.g. alarm, bypass, tamper) from zones to specific destinations.
Pre-conditions
• The zone must have valid zone options programmed (see "Programming Instructions for
Zones" on page 90), by default you should not need to modify these.
• The zone must be allocated a valid Area Group (see "Programming Instructions for
Zones" on page 90).
Destination = phone@u1
Event List = 4
Next Channel = 0
Format = Email
Destination = alex@home.com
Event List = 1
Channel Attempts = 3
Next Channel = 2
Area sends account
number and event to
Channel Group
Channel Group sends
Event to every Channel it
contains
Event List = 1
Channel Attempts = 3
Next Channel = 0
After failing Channel Attempts on the last back up channel,
Aritech Reliance XR will go back to the first Channel in the chain
Report Attempts = 2
Channel checks if the event is on its Event
List, if yes it will attempt to send, if not
then it stops
If it does not succeed after Channel
Attempts, it will try sending on the next
Channel
Aritech Reliance XR attempts to
send event via email using the
UltraSync servers
Aritech Reliance XR attempts to
send event via push notification
to smartphone. Event list
number always matches
channel number.
Event Lists filter
events from
passing through
the Channel
To Next Page
Loading...
