Installation and Programming Guide 71
Device Info
Click Devices – Device Info to show all expansion devices:
The Device Info menu allows:
• Adding and removing of devices – click Remove Device, Auto Enroll, Manual Enroll,
or Add Device under the device category.
• Identification of devices – click Turn on / off Buss LED to flash an LED of the specific
device.
• Re-ordering of devices – drag and drop the device to re-number it, use the “Slot
condition after removing device” to determine if DLX900 should refresh all device
numbering or to reserve the device number for future use.
• Display of device information including firmware and serial number.
• Access programmed data – select the device and click Display Stored Data, this is
the same as accessing the device via the Devices Menu.
• Export of programming information for a specific device – select the device and click
Create file. DLX900 will create a special file. This file can be copied to a USBUP and
then inserted into a suitable device to program it without a computer.
• Export control panel information for use with USBUP – on the Control Info tab click
Create file to save current panel programming to a special file. This file can be
To Next Page
Loading...
