Installation and Programming Guide 27
Installing Panel
1. The Aritech Reliance XR should be located away from damp areas (e.g. bathrooms,
kitchens), away from sources of heat, dust or interference (e.g. air conditioners,
washing machines, dryers, refrigerators) and away from external walls.
2. The metal enclosure should be installed with the door opening from the top to bottom.
3. Guides are cut into the enclosure to hold the
panel, two on the top and two on the bottom. Two
plastic brackets are pre-installed on the Aritech Reliance
XR. Slide the panel into the guides as shown in the
diagram. The terminal strip should face towards you
once installed.
4. A plastic strap is provided to allow the door to form a
temporary surface to hold light parts.
Installing Legacy NX Modules
Inside the enclosure there are several 2-holed insertion
points. These allows for either vertical or horizontal
placement of legacy NX modules. Each insertion point has
a larger hole and a smaller hole.
1. The black plastic PCB guides feature a groove to hold
an expansion module. The end with the half-moon
protrusion fits into the larger hole. The smaller hole is for
the screw.
2. Place the first black plastic PCB guide in the top
insertion point, groove facing downward. The half-moon
protrusion will be in the large hole. It does not require
force to insert. Insert one of the provided screws into the
smaller hole (from inside the enclosure) to secure it in
place. A screwdriver should reach through the groove that
runs the length of the guide to tighten the screw. The
second PCB guide should be positioned opposite the first
(groove facing up) and placed in the lower insertion point,
using the same procedures described above. Once
mounted, screw it in securely.
3. The NX module should slide freely in the grooves of
both guides.
To Next Page
Loading...
