Carrier Aritech Reliance XR Series - Programming Instructions for System Event Reporting

Installation and Programming Guide 121
Example
Next
• Program Users.
• Program advanced Schedules and Alternate Zone Profiles.
Programming Instructions for System Event Reporting
Pre-conditions
• Communicator must be programmed (see "Programming Instructions for
Communicator" on page 107).
• Event Lists must be programmed (see "Programming Instructions for Event Lists" on
page 112).
• Channels and Channel Groups must be programmed (see "Programming Instructions for
Channels" on page 114).
Notes
The system event will only be reported by a channel, if that Channel includes that event in
the associated Event List(s).
Channel Group 1
Channel 1
Channel 4
Channel 6
Zone 3 in Alarm
Area Group = 1
Area Group 1
Menu 12 – Area Groups
Area 1
Area 2
Menu 4 – Areas
Channel Group 1
Area 1
Event sent to lowest Area
Channel 4
Control Room 2
Event List = 1
Next Channel = 5
Channel 6
Email
Event List = 2
Next Channel = 0
Channel 1
Control Room 1
Event List = 1
Channel Attempts = 3
Next Channel = 2
Menu 18 – Channel Groups
Area sends event to
Channel Group
Channel Group sends Event
to every Channel it contains
Menu 5 – Channels
Channel 5
Control Room 2
Event List = 1
Next Channel = 0
Channel 2
Control Room 1
Event List = 1
Channel Attempts = 3
Next Channel = 0
Channel checks to see if the event is
on its Event List, if yes it will
attempt to send, if not then it stops
Menu 3 – Zones
If it does not succeed after Channel
Attempts, it will try sending on the
next Channel
Zone sends alarm to Area group