24 Installation and Programming Guide
Aritech Reliance XR Terminals
Top to bottom:
• Antenna 1 – after the board is installed in
the metal enclosure, insert the antenna
with the corresponding icon.
• Antenna 2 – after the board is installed in
the metal enclosure, insert the antenna
with the corresponding icon.
• LAN-, LAN+, NEG, POS – terminals for
Aritech Reliance XR RS485 bus.
• S1 LEARN – enrollment button, hold
down for 3s to activate automatic device
enrollment feature. Hold down while
powering up to reset the "installer"
account to master installer user type with
9713 PIN.
• TERM – term link for Aritech Reliance XR
RS485 bus. A TERM link should be
installed on the two furthest devices.
• AC, AC, EARTH – connect transformer
(16VAC 1.5A) to terminals for power.
• OUTPUT 3- – open collector output
switches to ground, follows “ready” state
at default.
• - BLACK, + RED – connect leads to 12V
Sealed Lead Acid backup battery.
• AUX+, BELL- – supervised output for
connecting an external 12V siren or
internal piezo screamer.
• OUTPUT 2- – open collector output
switches to ground, follows “any alarm”
action at default.
• OUTPUT 1- – open collector output
switches to ground, follows “any siren”
action at default.
• DATA, COM, POS – NetworX 3-wire bus
for legacy modules and keypads.
• ZONE 1 to 4, COM – terminals to connect
to zones. Supports single EOL, zone
doubling, and dual EOL tamper
monitoring.
• J14 – Ethernet WAN link header must be
fitted if no communicator module is
installed and must be removed to
accommodate communicator module.
• Ethernet – connect Ethernet cable to
RJ45 socket to provide internet
connectivity to Aritech Reliance XR.
• J13 USBUP – 5-pin connector used to
upgrade and program Aritech Reliance XR
with USBUP tool.
• TAMPER – connect to panel box tamper.
• J11 – terminal to connect communicator
module to Aritech Reliance XR.
To Next Page
Loading...
