Case IH 9250 - Tilt Sensitivity; Tilt Balance; Feathersight - HP Balance

15
Settings
Tilt Sensitivity
If the head is too jumpy from side to side – decrease sensitivity. If you would like the head to be more
responsive – increase sensitivity. To change this setting go to >>Settings>>Tilt Sensitivity in the Insight™
box. The range is from 5 to 95 with a default setting of 50.
Tilt Balance
If the head is consistently running higher on one end than the other, Tilt Balance manually tweaks the
combine height inputs to level it out. Use tilt balance only after eliminating other possible solutions.
1. Before adjusting tilt balance,
• Double check to make sure head frame is level and snouts are adjusted correctly
• Re-calibrate Insight or Horizon box on a at, level surface
• Re-calibrate combine on a at, level surface
2. If head is still not running level, adjust the tilt balance setting.
• Default tilt balance value is 100
• Lowering the tilt balance number will lower the left end of the head
• Raising the tilt balance number will lower the right end of the head
3. Tilt balance setting will only last until the next calibration.
• Do not recalibrate combine without resetting tilt balance to 100
Feathersight
®
- HP Balance
This setting is only applicable of you have installed and calibrated the optional feathersight
module.
1. To change this setting go to >>Setup>>Optional Modules>>Feathersight>>HP Balance in the
Insight™ box.
What to know:
• This setting is the percentage of the height response determined by the height sensors – as
contrasted with the height response determined by the pressure sensor
• Changing this setting will not affect the tilt response
• This setting is only available when an auxiliary (pressure) sensor is detected during Insight
calibration
• The default value is 65 when an auxiliary (pressure) sensor is detected and 100 if no auxiliary
(pressure) sensor is detected
Setting Hints:
• To increase the height response for the height sensors, increase the HP Balance
• To increase the height response for the pressure sensor, decrease the HP Balance
• If you know that you intend to run with the header always on the ground, you may want to
decrease the HP Balance
• If you know that you intend to run with the header always in the air, you may want to increase the
HP Balance or recalibrate Insight™ with the pressure sensor disconnected to disable the pressure
sensing mode